jaewalk.blogg.se

You should use wood - because most other surfaces will allow the firing pin to slip and could cause harm to you or damage to your surroundings.

3) Set the safety lever to point straight upward as shown in figure 3.Ĥ) Pull the bolt to the rear of the receiver.ĥ) Swing bolt release lever on left side of receiver and remove the bolt.Ħ) Figure 6 shows the retaining pin on the bolt sleeve.ħ) Push the retaining pin in and rotate the bolt counter clockwise.Ĩ) After completely unscrewing the bolt sleeve from the bolt body, remove from the bolt body.ĩ) Rotate the extractor (clockwise if holding bolt as shown in figure 9) until it rest outside the groove on the front of the bolt body.ġ0) Slide the extractor forward and off of the bolt body.ġ1) The bolt has a lug that fits into a channel on the extractor as shown in figure 11.ġ2) Make sure you have a block of wood handy to place the firing pin against as show in Figure 12.ĭo not use your wife's dinner table - the tip of the firing pin will leave a very deep indentation in the wood.